Asbestos Wall and Ceiling Removal in Adelaide
Clear scope and one fixed written price before work starts.
SafeWork SA licensed. We'll be in touch within 30 minutes.
The short answer
Flat sheet ceilings and wall sheeting are common in older Adelaide homes.
We test first, seal the room, take sheets out whole,
clean the frames and get the room independently cleared before you reline.
Wall and ceiling removal is quoted on site.
About wall and ceiling sheeting in Adelaide
Opening up a kitchen,
adding a doorway or replacing a sagging ceiling all mean cutting into old
sheeting. That is where most accidental exposure starts.
We seal the room, keep the sheets damp and take them out whole.
You get the room back clean, cleared and ready for the plasterer.
How we do walls and ceilings work
- 1
Test
Each different sheet is sampled.
- 2
Seal the room
Doors and openings sealed, furniture out or covered.
- 3
Remove whole
Fixings out, sheets lowered or lifted off intact.
- 4
Clean and clear
Frames vacuumed, room independently cleared.
The asbestos rules in South Australia
When your home was built
Built or renovated before the mid-1980s: asbestos products highly likely.
Mid-1980s to 1990: likely. After 1990: unlikely but not guaranteed.
Only a NATA accredited lab test confirms it.
Class A or Class B
Bonded asbestos is set firm in cement sheeting.
Friable asbestos crumbles by hand. Class A covers friable and bonded asbestos.
Class B covers bonded only.
Licensed work means more than 10 m² of bonded asbestos,
or any friable asbestos.
Air monitoring for Class B too
In South Australia an independent licensed asbestos assessor must do air
monitoring before and during licensed removal,
for Class A and Class B work alike. That is stricter than some other states.
Clearance before anyone moves back in
After Class A work, an independent licensed assessor does the clearance.
After Class B work, an independent competent person or assessor does it.
The area is only reoccupied after clearance.
What moves the price
Show the 5 price factors
- Area in m²
- Ceiling or wall
- Textured or crumbling coatings
- Furniture and access
- Roof space condition above ceilings
How it works, start to finish
One fixed quote, with independent air monitoring and clearance for licensed removal.
Quick chat. Tell us what you found and we tell you straight if it can wait.
Testing if needed. A small sealed sample goes to a NATA accredited lab for a clear answer.
Fixed quote. One written price for the work, the wrapping and the disposal.
Neighbours told. We let next door know what is happening, when, and for how long.
SafeWork SA notified. For licensed removal, SafeWork SA hears from us at least 5 days before work starts.
Independent air monitoring. An independent licensed assessor checks the air before and during licensed removal.
Removal. The area is sealed, sheets come out whole and damp, then double wrapped.
Independent clearance. Someone independent checks the area before anyone uses it again.
Waste to a licensed facility. Wrapped waste goes to a licensed facility and you keep the paperwork.
Walls and ceilings: your questions
What about textured or popcorn ceilings?
Test before anyone scrapes. If a crumbly coating contains asbestos,
it is friable and needs a Class A removalist.
Can I stay in the house?
Usually, but not in the work area. It stays sealed until clearance.
Is it safe to hang a picture?
One small nail into sound sheeting is low risk.
Drilling, cutting or sanding is not. Test first if you are unsure.
How likely is asbestos in a home my age?
Homes built or renovated before the mid-1980s are highly likely to contain
asbestos products. Mid-1980s to 1990, likely.
After 1990, unlikely but not guaranteed.
Only a NATA accredited lab test confirms it.
Can I remove asbestos myself in SA?
SA guidance says a homeowner working on their own home does not legally need a
licence, but it strongly recommends a licensed removalist.
A contractor without a licence can only remove 10 m² or less of bonded
asbestos per project and cannot split a job to get under that.
Friable asbestos always needs a Class A removalist.
What does a clearance certificate cover?
It confirms the work area is fit to use again after removal.
After Class A work, an independent licensed assessor does the clearance.
After Class B work, an independent competent person or assessor does it.
The area is only reoccupied once clearance is done.
Request an asbestos quote
We will be in touch within 30 minutes. If it can wait, we will say so.
If it should not be touched, we will tell you what to do in the meantime.
Then we do the job ourselves, start to finish.
- No photo upload needed. Just describe it.
- Your details are used only to answer you.
